Problems encountered when using different layers for cutting and carving

Terrelle

Kategoriler:

Lazer

Etiketler:

Laser cutting
Laser carving

846

Çeviriyi gör

2024-09-12

Hi Folks,
i want to cut Parts for a Modell airplane, but there is only small differences between this parts, so i have to engrave some Numbers on them.
I marked this Numbers and set them to Layer 02. In cutting options i reduced the Laser Intensity so that he only engrave this parts.
But how can i set Lightburn, that its doing First the engraving and after that cut? Just Change all Layers back? So that Engrave Settings is on Layer 00 and Cut Settings are on Layer 01?

Any Ideas?

LWE

2024-09-13

Set ‘order by layer’ in the ‘optimization settings’ as shown below. Then have your engrave layer 1st and the cut layer 2nd in the cuts/layers palette.

Çeviriyi gör

Yanıtla

İlgili öneriler