See power at a given point in grayscale

Smith

Kategoriler:

Lazer

Etiketler:

LightBurn

866

Çeviriyi gör

2024-01-11

Hello everyone,
I’m trying to engrave using grayscale mode, I have a hard time figuring out which part is at full power, which part are in a small power.
Is there a way to see the power it will engrave at a given point before launching the engraving ?
Regards.

Cyril

2024-01-12

If you enable “Shade according to power” in Preview, it will show you the relative power differences in the engraving based on grayscale value. However, I don’t believe this shows you the absolute power level that will be used to engrave after translation to Max and Min power levels.

Çeviriyi gör

Yanıtla