chanelink logo
CHANELINK
Türkçe

Sculptfun S30 Ultra Fan Issue

Kategoriler:
Lazer
Etiketler:
647
1
Çeviriyi gör
2023-10-16

Hello,

I have just cleaned my laser top to bottom but I can’t figure out where this plug is supposed to go. It is a part of the air assist fan, but I don’t see a port for it to plug into.It is a tiny white plug that is on the brushless DC fan. Please help!
C

    • Liam

      2023-10-17
      The fan is connected to the control board of the laser. Since this board is now mounted inside the module, you need to remove the control board as well. There are screws at the back to hold the control board. It won’t be that easy to assemble it again. Maybe next time try to keep the fan connected.
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor