Air Assist - what downside to running it throughout the project

Terrelle

Kategoriler:

Laser

Etiketler:

LightBurn

847

Çeviriyi gör

2023-06-16

Hi there, I’m new to laser work and Lightburn. Using second hand a LaserMaster 2. I was told to use the air assist when ctting. I can understand why this needs to be used.If I were to leave the air pump running even while burning lines what effect would it have on the outcome? I can’t work outwhat downside its to running it for the whole project.

Patrick

2023-06-19

The air assist serves two purposes: blow the smoke away from the part to reduce discoloration, and to blow the smoke away from the laser lens. That implies leaving it on all the time (for all layers).

Çeviriyi gör

Yanıtla

İlgili öneriler