chanelink logo
CHANELINK
Türkçe

Start Position Not Right

Kategoriler:
Laser
Etiketler:
921
1
Çeviriyi gör
2023-06-09

Hey all, not sure why or when this started happening, but when I used to make a box and put on T1, normally the Green Start Position Square would be at the top left corner of that box, but now I’ve resized that box and that start square does not want to follow my left corner, it’s just floating all around by itself? what’s going wrong? is there a setting I must have accidentally hit or…?
C

    • Payson

      2023-06-10
      You almost certainly have an unaccounted for shape elsewhere on the workspace. This is likely going to be from one of your other layers that are not being shown. Keep in mind that all layers are factored in for job origin.
If you only want the selected shapes to be considered for origin then enable both “Cut selected graphics” and “Use selection origin”.
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor