chanelink logo
CHANELINK
Türkçe

Compatibility between lightburn and the RNR Ecomotion board

Kategoriler:
Lazer
Etiketler:
913
1
Çeviriyi gör
2023-05-26

Good morning,
I am building a homemade 60w CO2 laser machine and I would like to know if ligthburn is compatible with the RNR ecomotion board.
If so, I can create and run g-code inside lightburn, without needing mach3, correct?
And i need some special driver?
Thanks a lot for the help.
C

    • Henry

      2023-05-27
      If it runs Mach3 today then no, it’s almost certainly not compatible with LightBurn. You may be able to generate gcode that could be run in Mach3 but no certainty in that and you’d likely need to modify the gcode in some way.
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor