chanelink logo
CHANELINK
Türkçe

Designs are flattened on the bottom of the image

Kategoriler:
Λέιζερ
Etiketler:
823
1
Çeviriyi gör
2023-05-05

When I import a .png file it looks fine in the software. But when engraving, the bottom of the image is a little compressed. It helps to put a point under it, so the design is not the lowest point, but isn’t there a better solution?
C

    • Miller

      2023-05-06
      Yes, you were right! We fixed it. We had to change the Backlash to 0.400.
Sorry I doubted you. It was because I didn’t understand what you mean. Here is a screenshot of the settings. You find these settings under Edit in the Lightburn software.
      Çeviriyi gör
      Yanıtla
    İlgili öneriler
    Topla
    Rapor