chanelink logo
CHANELINK
Türkçe

Change settings in mid burn

Kategoriler:
Lazer
Etiketler:
946
1
Çeviriyi gör
2023-03-18

Hi can settings be changed and saved during the burn. I would like to change the number of passes on a particular layer that is being engraved. Or would I have to wait till current layer is done then start from the beginning again then go over it
Thanks
C

    • Abel

      2023-03-20
      I think if you have the console open, it switches to allow you to control the speed and power values with sliders within a certain range…

You would have to note them for entry later, I don’t think they are saved anywhere… It also works in percentage… if I remember correctly…
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor