chanelink logo
CHANELINK
Türkçe

Restarting the laser in the middle of a job, once laser has been turned off

Kategoriler:
Laser
Etiketler:
860
1
Çeviriyi gör
2023-03-15

Can I restart a project half way through the job, when it has been turned off for the night?
I have a long project and I cant watch it over night, and don’t want to leave the laser on over night. But i also don’t want to have to start again.
Thank
C

    • jessie

      2023-03-16
      The way I do it is…
Use the PREVIEW function, press PLAY. Move the slider function to the right until the timer matches where you stopped (I used the image as a rough guide, then fine tune to the time stamp). Press START FROM HERE button.
        Çeviriyi gör
        Yanıtla
      İlgili öneriler
      Topla
      Rapor