What settings may cause dots to appear at the intersections of lines? It looks as if the laser is pausing at each corner. Note: The vertical line on left is 3mm in length and the horizontal lines are 8mm in length. DSP AWC708 Controller LightBurn 1.7.07

• Laser

Durell

03-24

825

3

0

I have no problem putting text on a circle path. I can even figure out how to place it on the bottom and it be readable. My question is how do I remove the circle and the text stays curved? When using Framing, it creates a problem even if it is No Output and Not Visible selected....

• Laser

Durell

03-03

807

2

0

Hi, I just purchased “Longer” laser, my problem is when it homes it doest stop but keeps on vibrating off the side bars, I can’t see any sensors, I’m thinking it may be a setting I need to open.

• Laser

Durell

02-07

1.1K

2

0

let’s say I have 2 parallel curves that are close to each other… I would like to select the nodes of one of the 2 curves without also taking the nodes of the other. how do I do it? if I box the nodes I also intercept the nodes of the other curve and I haven’t found a button to se...

• Laser

Durell

2024-11-26

949

6

0

I am trying to update my camera overlay but it is constantly grayed out. I have tried doing the alignment multiple times but haven’t had any luck

• Laser

Durell

2024-11-04

1K

1

0

When I try to combine text as shown, the Weld function works sometime and not others. I really don’t get it.

• Laser

Durell

2024-10-26

959

3

0

Judging replication method: Along the axis of the helical gear, looking towards the direction of the external helical gear development, the helix forms a diagonal line from the bottom left corner to the top right corner, that is, the direction of clockwise movement; The opposite ...

• Gearing

Durell

2024-06-06

927

1

0

Laser marking is currently one of the most widely used laser processing technologies. Its principle is to use a highly concentrated laser beam to instantly evaporate part of the material surface, forming an indelible mark. Laser marking has the advantages of fast speed, good text...

• Laser control
• Laser marking

Durell

2024-05-16

874

2

0

I am currently working on a design for fault diagnosis of three-phase asynchronous motors. The general idea is to build a model, obtain normal and fault signals, and finally use wavelet transform spectrum analysis. However, it is currently unclear how to model, what model is appr...

• Motor
• Asynchronous motor

Durell

2024-04-28

1.2K

1

0

ALARM:1 Hard limit triggered. Machine position is likely lost due to sudden and immediate halt. Re-homing is highly recommended. [MSG:alarmCodeCodeIntHandle:1 ] Grbl V1.055 [‘$’ for help] [MSG:Check limits] [MSG:‘$H’|‘$X’ to unlock] [MSG:Caution: Unlocked] ok Grbl V1.055 [‘$’ for...

• LightBurn

Durell

2024-01-29

972

2

0