chanelink logo
CHANELINK
Русский

Not Marking

Категории:
Laser
Теги:
999
1
Посмотреть перевод
2023-02-24

I have MP-30 LiteMarker 30W Split Laser Engraver… I have EZCAD 2 and have installed the driver just fine. I have adjusted the focus. I have used the EZCAD 2 that was shipped with the laser.
C

    • Payson

      2023-02-27
      1. Check if all buttons are turned on
2. Check whether the driver is connected correctly
3. Check parameter settings, output or fill
4. Turn the rotary wheel up and down to check whether there is laser emission
        Посмотреть перевод
        Ответить
      Актуальные рекомендации
      Собирать
      Сообщить