Laser Position is not matching what it looks like on Lightburn

John Trant

Категории:

Лазер

966

Посмотреть перевод

2023-02-23

I can set the laser to the home position with no problem but when I try to use the “Set Laser Position” icon to line up the laser on the bed, it does not go to the same position that is on the screen workspace. It seems to go in the right direction on the bed, but not to the spot where it’s showing on the workspace in Lightburn. Here’s a series of pictures to show what is happening.

Nugent

2023-02-24

If you use Arrange->Move Laser to Selection->Move Laser to selection center. Do you have the same behavior?
If so, can you run these commands in Console and return output:
$H
$I
$$
$#
?
Note that the first command will home the laser so be prepared for it.

Посмотреть перевод

Ответить

Актуальные рекомендации