chanelink logo
CHANELINK
Русский

How to set up engraving for upgrading a 10 watt laser to 40 watts

Категории:
Лазер
Теги:
524
2
Посмотреть перевод
10-17
I am upgrading the 10 watt laser to 40 watts. Both are diode lasers. I carved on maple and hardwood with a 10 watt laser at a speed of 1500 millimeters per minute and a power of 30%, and the effect was very good.
When I receive a 40 watt machine, should I maintain the same processing speed per minute and only reduce the power by 1/4? That is to say, maintain at 1500 millimeters per minute and reduce the power to around 8%.
C

    • Keegan

      10-20
      There is no direct mathematical relationship between laser power and wood processing effect. You really need to use a higher power laser for testing in order to find results that are effective in every situation.
        Посмотреть перевод
        Ответить

      • Robert Evans

        10-21
        I suggest using LightBurn's built-in material testing to understand the functionality of your specific module.
          Посмотреть перевод
          Ответить
        Актуальные рекомендации
        Собирать
        Сообщить