chanelink logo
CHANELINK
Русский

Laser cutting of acrylic with rough edges

Категории:
Tia laze
Теги:
350
1
Посмотреть перевод
09-29
Hello, I am cutting extruded acrylic and the edges are very rough and appear to have little bubbles through out it. I've cut this stuff before with a great flame polished finish. Any advice on why this is happening?
C

    • Williams

      09-30
      Have you tried lowering the amount of air assist you are using? Too much and it will cool the cutting zone.
        Посмотреть перевод
        Ответить
      Актуальные рекомендации
      Собирать
      Сообщить