Manuals and software

Geozapata

Категории:

Ruida

Теги:

297

Посмотреть перевод

06-14

Hello, I'm upgrading an oscillating knife cutting machine. The machine had a Galileo controller. The PC used to operate it lost its hard drive. I couldn't configure the software from the backup I had.
I purchased a Ruida RDD6616u controller from Wavetopsign on Aliexpress. I asked them for the installation manual and software on several occasions. I received the software, but it doesn't connect to the PC. In fact, it doesn't appear in the list of compatible cards. I've also searched for it on Google and sent several emails, but I haven't received a response.
Currently, the machine moves from the touch screen. The X and Y axes are calibrated. The suction works. The oscillating knife also works. I haven't calibrated the rotation and can't activate the grating tool. I did this using the RDD6584g manual.
The real problem is connecting the controller to the PC. I have two laser machines with Ruida controllers connected, one via a network cable and the other via USB, so I have some experience with the connection.
If anyone could help me with the software, the manuals for this specific model, or a guide, please.

blue sea

06-16
```
Hello, the following recommendations are given based on the situation described:
1. Select the corresponding firmware version number option when installing the software: 32. XX.XX/36.XX.XX。
2. The machine type selects double cantilever (X) / double beam (Y) according to the actual equipment.
3. The software parameter setting machine configuration needs to be selected correctly.
4. The motherboard model is the same according to the model of the control card.
5. Please provide an email address that can accept documents, and the corresponding product manual, software program and manual will be sent to this address.
```
Посмотреть перевод

0

Ответить
- blue sea
  
  : The following is a screenshot of the installation software and a picture of the configuration parameters of the software machine, please refer to it!
- Geozapata
  Ответить
  @blue sea
  
  : Hello, it seems the firmware is the problem. The machine shows firmware 42.01.11. In the software, the option to select the firmware is grayed out and I can't change it. My email is geozapata@gmail.com, it's registered in my profile. Thank you very much in advance.
- Geozapata
  Ответить
  @blue sea
  
  : Just in case this is another email, geozapata@digishopecuador.com, geo666@hotmail.com
- Другие 6 ответы