Missing laser control command in settings (v 1.7.04)

Narrator

Категории:

Лазер

440

Посмотреть перевод

01-16

Hi All,
I recently updated to v1.7.04 from very old version. I’m setting up a diode laser machine (that was working on that old version) and have upgraded the controller to an MKS SBase I had lying around), running Smoothieware.

What happened to the “Laser Control Commands” in Device Settings? I’m struggling to get the laser to fire properly.

It’d also be really nice to see the gcode actually sent to the controller, is that available somewhere?

Miller

01-17
```
Check if LightBurn is in beginner mode.
Post a screenshot of LightBurn laser window for us to see the same as you.
```
Посмотреть перевод

0

Ответить
- Narrator
  
  : I thought I did paste it! but didn’t! So here you go for that… used to be in the highlighted area…
- Narrator
  Ответить
  @Narrator
  
  : and here’s the settings… So, nope - not in Beginner Mode.
- Miller
  Ответить
  @Narrator
  
  : Setting up a Smoothie don´t have that options Check the config.txt.