chanelink logo
CHANELINK
Русский

Speed and laser power settings

Категории:
Лазер
Теги:
701
1
Посмотреть перевод
2023-12-27

My computer crashed while engraving earlier. Image had a 1 hour 15 minute time estimate. Same engraving this morning was close to that estimate. Trying to burn image this afternoon, estimate is not 1 hour 40 minutes. Laser head doesn’t change speeds when changing settings while doing test burns.
Any ideas on what setting(s) need to looked at?
C

    • roy

      2023-12-28
      The preview estimates gets the data to compute this from
Might try Edit → Device Settings → Additional Settings
Then click on Read From Controller
This will read the machines values… it’s possible they haven’t been updated
      Посмотреть перевод
      Ответить
    Актуальные рекомендации
    Собирать
    Сообщить