Lines don’t stay together when I “trim line”

Vasili

Категории:

Láser

Теги:

LightBurn

730

Посмотреть перевод

2023-11-28

I intend to cut two lines to transform the two areas into one. When I do “trim line” the line n stays in one. Then it creates open part problems. Does anyone know a way to not have to see each zone to manually join these points that don’t stay together?

roy

2023-11-29

Just grab the line end point (the green square) and drag it to another one that you want to connect it with. LightBurn has no idea what you intend by trimming, so it doesn’t automatically join things back up.

Посмотреть перевод

Ответить

Актуальные рекомендации