chanelink logo
CHANELINK
Русский

Z axis control between cut passes

Категории:
Лазер
Теги:
569
1
Посмотреть перевод
2023-10-13

Assuming that i have cut optimization by layer and i have only 1 layer with multiple passes to cut, is it possible to move the Z axis to raise it between one pass and the next with a pre-set distance?
C

    • Cyril

      2023-10-14
      Check the option “Z offset per pass” in Cut Settings.
        Посмотреть перевод
        Ответить
      Актуальные рекомендации
      Собирать
      Сообщить