Settings for neje 4max

John Trant

Категории:

Лазер

Теги:

LightBurn

638

Посмотреть перевод

2023-08-24

If I try to start the laser He always Go Up first and than start .
So he runs against the switch and lost the steps he need. look pic.

Can Anyone Help me whit this

Tory

2023-08-25

What are you expecting to happen?
I suspect you have either a material height set or a Z-offset configured on your layer.
If you want no movement then trying the following:
1. In Edit->Device Settings enable “Relative Z Moves Only”
2. Remote any Z-offset in Cut Settings

Посмотреть перевод

Ответить

Актуальные рекомендации