One or more shapes are crossing the edge of the machine workspace

Henry

Категории:

Лазер

Теги:

LightBurn

355

Посмотреть перевод

2023-06-15

I use a jpeg file to engrave a picture. The picture is not filling the full jpeg frame and to maximize the woodplate I rotated it about 20 degrees. The picture I want to engrave fits on the workspace, but the edge of the jpeg frame (as it is retangular) runs over the workspace. I believe this is the issue why LB is not starting to engrave this layer.
Is there a way to ovecome the error message and start engraving ?

Any idea ?

Aaron

2023-06-16

2 methods:

1. Using mask
1a. Create a shape around each raster image
1b. Select image and shape
1c. Right click on selection → Apply mask to image
1d. Right click on selection → Flatten mask

2. Trace raster image
2a. Select image
2b. Tools->Trace Image

Посмотреть перевод

Ответить

Актуальные рекомендации