Weak LaserNo r Windows 10

David

Категории:

Laser

Теги:

LightBurn

958

Посмотреть перевод

2023-06-13

I have a new machine a Atomstack S10 PRO, Laser is 10-11 Watts max and my problem is that when using Lightburn I have to usemultiple passes to burn through 1mm veneer yet without changing a thing I switch to Laser GRBL and at 100% it will burn through the veneer, I do not understand what if any I am doing wtong? Why is it that both programs are set at 100% yet Light burn is cobsiderably weaker?

Aaron

2023-06-14

Go to Edit->Machine Settings and check the value for $30. It will likely be 255 or 1000. Then go to Edit->Device Settings and compare the value in S Value Max. If they do not match, change the value of S Value Max to the same value found in $30.

Посмотреть перевод

Ответить

Актуальные рекомендации