Going from engrave to cut and using air assist

Cyril

Категории:

Lazer

Теги:

LightBrun

1.1K

Посмотреть перевод

2023-06-07

Hi All
Newbie question
How to engrave something then cut around it in lightburn using air assist. As I understand it AA is best used for cutting only. If you’ve only got something like aquarium air pump is there a way to pause lightburn from starting the cut till your ready. This is for a diode laser.
I know on Sculpfun S30 it’s done automatically thru software.
Hopefully this makes sense.
Cheers Geoff

Vasili

2023-06-08

I highly recommend leaving AA on all the time. Otherwise, your lens will get dirty and break fast. AA is a great lens protection function.
If you want to automatically control the AA, you can add a relay to most boards

Посмотреть перевод

Ответить

Актуальные рекомендации