OmTech Polar Exhaust fan controlled by Air Assist?

Robert Evans

Категории:

Лазер

Теги:

LightBurn

869

Посмотреть перевод

2023-06-02

I have the OmTech Polar and it seems the exhaust fan is controlled by the air assist setting. Is there a way to change this? I would like the exhaust fan to run anytime the laser is working, and not be tied to the air assist setting.

Jamie

2023-06-05

There are a couple of outputs used by most of us with a Ruida.
When active the Status output sinks current. It becomes active anytime you run a job… The Wind sink, is active when a layer with air assist is enable and executed…

Посмотреть перевод

Ответить