chanelink logo
CHANELINK
Русский

New to lightburn and dont know how i would engrave this

Категории:
Λέιζερ
Теги:
930
1
Посмотреть перевод
2023-05-24

how should one go about making outlines? so for the green lines, i thought i could just use the option “fill” but that resulted in the whole picture getting engraved. i really wanna make big outlines, but i dont know how to do it.
C

    • Keegan

      2023-05-25
      Put the inner and outer shapes representing the outline on the same layer and use fill.
        Посмотреть перевод
        Ответить
      Актуальные рекомендации
      Собирать
      Сообщить