chanelink logo
CHANELINK
Português

The laser stops at various times during operation

Categorias:
Laser
Tags:
845
2
Ver tradução
2023-02-23

Hello everyone. I have an Ortur aufero laser 2 and a lightburn license. When engraving photos, the laser stops after a while and nothing can be done at various times. There is no such problem when cutting. I tried changing the settings and nothing helps. I change the settings according to the ortur manufacturer’s instructions. Even though the laser stops, time continues to count in lightburn, percentage of work stops. On another program it all worked out. What can cause the laser to stop?
C

    • Smith

      2023-02-24
      Can you confirm that you never have an issue in LaserGRBL but get this every time in LightBurn?
If so, then this is likely a setting issue.
First things first, make sure you’re not using mm/s as your units. If you are, change this to mm/min as you may not be comparing like for like in LaserGRBL. You can change this in Edit->Settings if this is the case.
        Ver tradução
        Responder
        • Smith

          : If that’s not the issue, then can you provide the following? 1. Full screenshot of LightBurn with design loaded and Cut and Laser windows showing 2. Screenshot of Edit->Device Settings 3. Save the design to gcode by going to File->Save Gcode. Save with a .txt extension and then upload the file here.

      Recomendações relevantes
      Coletar
      Relatório