Camera Overlay square in every corner except one

Jen

Categorias:

激光

Tags:

LightBurn

748

Ver tradução

2024-01-08

I bought a Camera kit for my Elegoo Phedca (20W Diode) Followed the instructions by the seller. I am getting a skewed bottom\right side edge that is driving me nuts. I am following the Camera Lens calibration and getting great numbers .07-.12 but every time its done it comes out looking like the attached image

Henry

2024-01-09

Try to get the camera more square to the frame and orthogonal to the bed. Additionally you may need to raise the height of the camera.

This will require you to go through camera alignment again if you change position or orientation of the camera.

Ver tradução

Responder

Recomendações relevantes