chanelink logo
CHANELINK
Português

Controlling Air Assist with OML 3

Categorias:
Laser
Tags:
593
1
Ver tradução
2023-11-20

Hello. I have an OML3 and would like to know how to control air assist from lightburn so the air flows when cutting and stop while engraving without me having to turn my pump on and off manually. I need to know about configiuration and hardware needed for this if it is possible. Thanks.
C

    • Vasili

      2023-11-21
      You need an electrically controlled air valve with driver to activate solenoid. I believe you use the coolant pin on controller for this. Control air assist in your cuts/layers.
        Ver tradução
        Responder
      Recomendações relevantes
      Coletar
      Relatório