Why does LB break up lines into 2mm segments in gcode?
Categorias:
Laser
1K
1
0
2023-07-05
C
John Trant
2023-07-06Assuming you don’t have perforation mode or tabs/bridges on I assume this is due to a setting on Smoothieware devices. Check if you have “Reduce Smoothieware pause delay” enabled. Disable this and retest to see if that changes the behavior.
0Responder
Recomendações relevantes
- 2022-09-13
-
Detection Laser Source- Line Laser Source
0 Respostas06-06 -
Invalid code ID:66
1 Resposta2023-05-11
