Burned corners of the object

Henry

Categorias:

Laser

Tags:

LightBurn

867

Ver tradução

2023-04-10

Please can someone guide me?
I still have burnt corners of the object. Classically, the square and all corners are black.
Min. my performance is already at the limit of the pipe and it is still the same on every material.
Also, please, where do I set the object to be, for example, 10x10cm and not 9.8x9.8 cm.
Thank you very much

Darren

2023-04-11

Yes, the axis calibration is what I needed. Thanks, I knew I read that somewhere.
The corners look almost good already. Ruida had a factory set start speed of 25, set to 5 it’s pretty good. Min Power set to 8, smaller value no longer burns horns.
Thank you very much everyone, my problem is solved.

Ver tradução

Responder

Recomendações relevantes