Need help w/ Xtool D1 pro Origin

Henry

Kategorie:

Laser

880

Zobacz tłumaczenie

2023-02-22

i am a total newbie to this i have a xtool d1pro 5w. i have just installed lightburn and the origin is in the back left corner of the machine and i cannot get it to move to the front left corner of the machine and the y axis is going in the wrong direction and so are the move buttons. x positive to the right, y positive to me should be going away from you, z positive is up. when i tell machine to go home it goes to back left corner but machine shows dot on front left

Clarence

2023-02-23

Your origin is likely setup incorrectly. Go to Edit->Device Settings and set Origin to top-left for your laser. However, this implies that you didn’t use the .lbdev configuration files provided by xTool.

Zobacz tłumaczenie

Odpowiedz

Relewantne rekomendacje