The cutting pattern is not closed or the light is uneven
Kategorie:
Ruida
825
1
0
2022-12-06
C
roy
2022-12-07① Set the takeoff speed to high ② Excessive idle speed ③ Excessive cutting speed ④ Cutting power is not adjusted properly According to the possible causes of the above points, re adjust them.
0Odpowiedz
Relewantne rekomendacje
- 2023-08-30
- 3 dni temu
-
No blowing during processing, no signal output
0 Odpowiedzi05-19 -
Press the test key ".", the cutting head is in the following state, but the jitter is large.
1 Odpowiedź2022-12-02
