chanelink logo
CHANELINK
Polski

Missing laser control command in settings (v 1.7.04)

Kategorie:
Laser
873
4
Zobacz tłumaczenie
01-16

Hi All,
I recently updated to v1.7.04 from very old version. I’m setting up a diode laser machine (that was working on that old version) and have upgraded the controller to an MKS SBase I had lying around), running Smoothieware.

What happened to the “Laser Control Commands” in Device Settings? I’m struggling to get the laser to fire properly.

It’d also be really nice to see the gcode actually sent to the controller, is that available somewhere?

 
C

    • Miller

      01-17
      Check if LightBurn is in beginner mode.
Post a screenshot of LightBurn laser window for us to see the same as you.
        Zobacz tłumaczenie
        Odpowiedz
        • Narrator

          : I thought I did paste it! but didn’t! So here you go for that… used to be in the highlighted area…

        • Narrator
          Odpowiedz
          @Narrator

          : and here’s the settings… So, nope - not in Beginner Mode.

        • Miller
          Odpowiedz
          @Narrator

          : Setting up a Smoothie don´t have that options Check the config.txt.

      Relewantne rekomendacje
      Zbierz
      Zgłoś