Rotating image distortion
Kategorie:
Laser
471
2
0
2024-11-01
C
jessie
2024-11-04Measure your engraved output and compare with design dimensions (to see if the problem is X or Y). Also test correct flat output by designing 1 squares with 50mm side and 1 with 100mm then engrave in a piece of cardboard and check dimensions.
0Odpowiedz-
: Hello, thank you for your reply. Flat, don't worry, the odds are good When rotating, I measured according to your requirements and found that the Y-axis is too large compared to the drawing (at 33.7 mm for light burning and 45 mm for real)
-
Relewantne rekomendacje
-
Ortur Rotary Chuck on OLM2 Pro S2 not working
1 Odpowiedź2023-06-25 - 2024-12-26
-
Lightburn scaled my SVG
1 Odpowiedź2023-05-23 -
How to adjust travel speeds when “HOMING”
1 Odpowiedź2023-05-09