chanelink logo
CHANELINK
Polski

When carving, the entire project cannot be covered

Kategorie:
Λέιζερ
704
2
Zobacz tłumaczenie
2024-10-03

Is there a way to set the machine to only engrave over the parts that are being engraved instead of the machine spanning the whole piece I’m trying to cut an engrave.

5 hours to engrave and cut these hexagons.
10 min to cut and engrave one single one
70 min if I did them each individually

would be a cool feature if you could engrave each location instead of it spamming the whole project line by line

carving
C

    • Tory

      2024-10-05
      Depends on how you set these in your cuts/layers window.
      Zobacz tłumaczenie
      Odpowiedz

    • Henry

      2024-10-09
      Under the ADVANCED tab you can also try FLOOD FILL. Try that on a preview screen and see how that works for ya.
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś