Tray Engraving – Without Head Crash,How should I handle it?

Hiroko

Kategorie:

Laser

Tagi:

Laser marking

1.2K

Zobacz tłumaczenie

2024-09-26

I have a ThunderLaser Nova 24. The head goes to the home position after the job has completed. If I am engraving in the bottom of a tray with say one inch sidewalls what would be the best way to instruct the head to stay within the confines of the tray when engraving is complete? Trying to avoid a head crash.
Thanks to all!

Nugent

2024-09-27

Ensure that ‘return to finish position’ is turned off in device settings.

Add a final layer with a 1000 passes that draws a small circle at low speed and 0% laser so that you have time to power off the equipment or otherwise intervene when the engraving is done?

Zobacz tłumaczenie

Odpowiedz

Relewantne rekomendacje