chanelink logo
CHANELINK
Polski

When I tried to install a rotating device to make glasses, I messed up the controller settings

Kategorie:
Laser
Tagi:
762
2
Zobacz tłumaczenie
2024-01-25

I am running an Atomstack X20 Pro and I tried to install the rotary to do glasses. I have completly messed up the controller settings. My laser isn’t framing or firing and keeps bashing against the rails. Is there a factory reset on the machine? I need to start again as I have done something very wrong.
C

    • Christian

      2024-01-26
      I dont think its the machine. I think your settings in Lightburn are not correct.

First thing to do is remove the rotary. And plug the connector back into the Y axis Then go to Laser Tools > Rotary Setup and disable the rotary. On the main screen under “Laser” make sure the Start From: is set to Absolute Coordinates. Then restart the machine and open lightburn and home the machine and see if it homes correctly.
      Zobacz tłumaczenie
      Odpowiedz

    • jessie

      2024-01-26
      Remember too
in console you can apply
$RST=*
command to reset your firmware to its defaults if you been changing settings there
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś