chanelink logo
CHANELINK
Polski

Last position question

Kategorie:
Laser
Tagi:
782
1
Zobacz tłumaczenie
2023-10-23

Is it possible with Lightburn to move the laser to last position with a command and not the mouse curser?
C

    • roy

      2023-10-24
      I’d suggest looking at using “User Origin” as your Start From mode. This may get you what you want.

In this case, place the laser where you want the center to be, then use “Set origin”. With Job origin at center position, your jobs should now run from center of specific user origin position.
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś