Can you import a two layer .DXF and automatically distinguish layers for cutting verses etching?

Jamie

Kategorie:

Laser

Tagi:

LightBurn

294

Zobacz tłumaczenie

2023-07-08

I am going to be purchasing a Boss LS-3655 soon, and have a question about Lightburn. For my application, I am running relatively simple files, but a large amount of them.

I will be loading these files in DXF format, which is all well and good, except I realize that it will be quite time consuming to manually select each part that I would like to cut and each part I would like to engrave. Especially with large files like the ones I will be running.

Is there an easy way to load files so that they will automatically have different layers that I can specify cutting/engraving all at once?

Would it work when importing a DXF with multiple layers? Or would it be better to have the lines be different colors in the DXF file itself and Lightburn would recognize this and place them in different layers automatically?

I hope that was clear.

Thanks!

Keegan

2023-07-10

"Or would it be better to have the lines be different colors in the DXF file itself and Lightburn would recognize this and place them in different layers automatically?"

This is precisely the way LightBurn deals with different colors in your original artwork. LightBurn looks at the colors used and does a ‘best-match’, placing each color on a different layer. You can also have these layers pre-set to cut or engrave, with the correct power and speed settings applied automatically. Once setup, the combination of these features allows you to import and go with your projects, producing as you’d like, with the minimal number of steps to achieve.

Zobacz tłumaczenie

Odpowiedz

Relewantne rekomendacje