chanelink logo
CHANELINK
Polski

Engraving offset circles

Kategorie:
Laser
Tagi:
417
1
Zobacz tłumaczenie
2023-07-07

With an image I created a circle with an offset by about 1 mm, and select fill. But when the laser cuts, it goes back-and-forth and back-and-forth. Takes forever. Is there a way that you can have the laser simply cut in a circular pattern - instead of going back-and-forth and back-and-forth to decrease the thousands and thousands of rapid moves?

 
C

    • jessie

      2023-07-08
      Suggest you look at using offset fill rather than normal fill in that case.
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś