chanelink logo
CHANELINK
Polski

Dirt in the cut

Kategorie:
Λέιζερ
Tagi:
812
1
Zobacz tłumaczenie
2023-06-19

do you know why when you cut in one direction (green arrow) it doesn’t get dirty and when you go back (red arrow) it gets dirty?
C

    • Abel

      2023-06-20
      The laser will traverse the red path in both directions unless:

Optimize Cut Path is turned on
Remove Overlapping Lines is turned on
The lines overlap within the tolerance distance

If your “larger” laser is a CO₂ (typical for a Ruida controller) and the material shifts slightly after the complete perimeter cut, then it’s charring the edge of the shifted material.
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś