Project Time Estimate Way Off

John Trant

Kategorie:

Laser

Tagi:

LightBurn

323

Zobacz tłumaczenie

2023-05-31

I’ve looked over this site and online and can’t seem to find the specific methodology for tweaking Additional Settings in Device Settings to get my project time estimate a lot closer to reality then what currently exists. Yes, I have clicked on read from controller - but that didn’t help time estimates at all. Does anyone have any information on how to tweak the various items/settings in Additional Settings?

Robert Evans

2023-06-01

Hi Jimbo - you can use that figure to adjust the ‘Cut Speed Scale’ and ‘Global Speed Scale’ entries in the Simulation Settings window. If your review estimate is approximately half the speed you expect, then set the global value to 200%

Zobacz tłumaczenie

Odpowiedz

Relewantne rekomendacje