chanelink logo
CHANELINK
Polski

Connects fine - project starts fine, stops mid-project. LightBurn reports “Busy”

Kategorie:
Laser
Tagi:
977
1
Zobacz tłumaczenie
2023-05-27

In my case it’s my Atomstack A10Pro. Connects no problem and will start to run a project, but randomly stops mid-project. Lightburn will still report “Busy” and no information about the stop on the console.
C

    • Gilbert

      2023-05-29
      You may have more success by starting a new thread.

I’m going to move this into the Atomstack Section and keep an eye on it. I’ll take the first shot at the problem by inviting you to copy and paste the ‘welcome message’ from the Console window in LightBurn and paste it into a reply here.

It’ll be helpful to know which board, which build date and which firmware version you have.
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś