My problem may be min & Max power?
Kategorie:
激光
366
1
0
2023-04-25
C
Henry
2023-04-26From your photo, I think it’s a nice quality, but I also see what you mean. However, it is unlikely to be your min/max settings because they will be visible all over your work. One way I test my max/min settings when engraving is to engrave a square (in line mode) e.g. 50x50mm and adjust min until the ends of the four sides meet without visible difference.
0Odpowiedz
Relewantne rekomendacje
-
My Ortur 2 S2 laser wont turn on
1 Odpowiedź2023-06-06 -
How to cut foam cotton with laser
0 Odpowiedzi02-28 -
Error 20 et 1 plus de gravure
1 Odpowiedź2023-05-31 -
Busy timer not correct
1 Odpowiedź2023-04-20 -
How to thicken lines with line tool
1 Odpowiedź2023-08-31