My CO2 laser is not following the cut before engraving sequence

Smith

Kategorie:

Laser

Tagi:

LightBurn

389

Zobacz tłumaczenie

2023-04-21

For the past couple week my Chinese CO2 laser is not following the cutting before engraving sequence. Also when cutting it is not prioritizing the inside cuts before the outside cuts.
I have tried factory resetting my ruida controller without success.
Is there anything else I should try?

Payson

2023-04-23

If you do a factory reset you will lose all the vendor information about how your machine works…
Most people that successfully do this, usually brick the machine… the controller works, but it doesn’t have the right data in it to operate the machine correctly…
This should be backed up somewhere anyway… such as a lost controller… via Edit → Machine settings.

Zobacz tłumaczenie

Odpowiedz

Relewantne rekomendacje