How to swap X and Y axis
Kategorie:
Лазер
831
1
0
2023-03-31
C
Liam
2023-04-01Likely, yes. But this is not just a simple configuration change within LightBurn. Assuming your machine allows GRBL configuration changes you’d have to do swap the wiring to the stepper motors and then make the GRBL configuration changes to adjust for that. If you also want to change homing location then you would potentially also change location and wiring of limit switches.
0Odpowiedz
Relewantne rekomendacje
-
Fire sensor deactivation from lightburn
1 Odpowiedź2023-03-03 -
Problem with setup
1 Odpowiedź2023-04-03 -
sistema allineamento specchi?
2 Odpowiedzi2023-02-20 -
Offset letter with internal closed shapes
1 Odpowiedź2023-05-27
