chanelink logo
CHANELINK
Polski

Cutting MDF with Sculpfun S9

Kategorie:
Láser
Tagi:
1K
1
Zobacz tłumaczenie
2023-03-28

Hi
I am trying to understand the cutting speeds and Laser diode power.
I have a Sculpfun 9 and have cut many pieces of 3mm MDF at a speed of 300 mm/m at an intensity of 80%.
I then tried to make a jigsaw puzzle. I stuck the picture onto the mdf using a spray adhesive. I used exactly the same settings and it did not cut through.
the only addition is a piece of paper glued onto the MDF
C

    • Kevin

      2023-03-29
      At a guess the answer is the glue. Always best to do a test in situations like this. The glue used in plywood has a drastic effect on the cutting and could well be the same when applied to paper and MDF. Don’t seem possible, but some glue is very hard to cut through.
        Zobacz tłumaczenie
        Odpowiedz
      Relewantne rekomendacje
      Zbierz
      Zgłoś