Dual outputs for Lasers

7E026F24

Categorieën:

Ruida

Tags:

106

Bekijk vertaling

07-20

Hi. I have a RDC6445G unit in my 130w CO2 laser. Normally in Lightburn I can choose a Tube Tpe of Glass, RF1, or RF2.

Now I want to add a Diode Laser to my unit so I can do very fine detail work that the 130W cannot.

My Ruida has 2 outputs, and depending on the mode it will either put out a 0-5v signal to drive the CO2 power supply.. or a PWM signal to drive the RF unit (which is what I want for the Diode.)

Is there anyway I can tell the Ruida to use a Analogue output on 1, and a PWM on 2. Is this something that can be set on the Ruida controller itself under Vendor Settings.

Also - what is the Vendor Setting password so I can some of these myself.

Many many thanks for any valuable advice you can give me.
Dave

blue sea

07-21

Hello, your feedback question about the use of equipment dual lasers, it is recommended that you use a unified wiring method, otherwise it may lead to laser light output out of sync or abnormal problems, the manufacturer's factory preliminary test password is RD8888, if the equipment manufacturer has modified the settings, you need to contact the equipment supplier for consultation, thank you for your product support!

Bekijk vertaling

Antwoord

Relevante aanbevelingen