The equipment cannot return to the positioning point after processing

Marshall

Categorieën:

Ruida

Tags:

anchor point
Return setting

449

Bekijk vertaling

05-19

Fault analysis:

1. Enable multiple positioning points
2. Failed to locate successfully
3. Panel button malfunction
4. Return setting error

Solution:

Upon checking the user parameters, it was found that the return method has been changed to return to the mechanical origin. Simply change the return to the positioning point

Geen opmerkingen

Relevante aanbevelingen

Volgen

Verzamel

Rapporteren

The equipment cannot return to the positioning point after processing

After cross cutting correction, the cross cutting is not aligned, and there is still offset

XY axis cannot be limited

What is the possible reason for the skew of graphics and characters when cutting?

Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always mov

The tool lift coordinate is set, but the tool is still lifted to the zero point coordinate during the cutting process.