chanelink logo
CHANELINK
Nederlands

A simple method for setting alignment reference layers

Categorieën:
Laser
951
3
Bekijk vertaling
03-06

Is there an easy way to set up an alignment guide layer that will appear when framing, but not be printed out?

For example, I have wooden plaques that vary by just a little on height and width. The design I have in lightburn needs to be centered on these plaques. While I have physical guides on my machine, I need to move them a hair or two manually to get them perfect.

I’d like to have some corner guides that make visualizing this easier. I’m aware I can turn the output/show on/off, but is there a way to modify that layer so that they show when framing, but are not engraved?
C

    • roy

      03-07
      Hi, just use a tool layer T1 or T2.
        Bekijk vertaling
        Antwoord

      • Keegan

        03-17
        You could make a grid array and either use T1/T2 for that or one of the other layers and turn off the output for this specific layer.
          Bekijk vertaling
          Antwoord
        Relevante aanbevelingen
        Verzamel
        Rapporteren